Microsens MS453490M Management Guide - Manual (Page 312)

C HAPTER 14 | Security Measures
Access Control Lists
– 312 –
B INDING A P ORT TO AN
A CCESS C ONTROL
L IST
After configuring ACLs, use the Security > ACL (Configure Interface) page
to bind the ports that need to filter traffic to the appropriate ACLs. You can
assign one IP access list and one MAC access list to any port.
CLI R EFERENCES
◆ "ip access-group" on page 688
◆ "show ip access-group" on page 689
◆ "mac access-group" on page 693
◆ "show mac access-group" on page 694
◆ "Time Range" on page 545
C OMMAND U SAGE
◆ This switch supports ACLs for ingress filtering only.
◆ You only bind one ACL to any port for ingress filtering.
P ARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Fixed port or SFP module. (Range: 1-10)
◆ ACL – ACL used for ingress packets.
◆ Time Range – Name of a time range.