Microsens MS453490M Management Guide - Manual (Page 522)

C HAPTER 21 | System Management Commands
Line
– 522 –
R ELATED C OMMANDS
parity (523)
exec-timeout This command sets the interval that the system waits until user input is
detected. Use the no form to restore the default.
S YNTAX
exec-timeout [seconds]
no exec-timeout
seconds - Integer that specifies the timeout interval.
(Range: 0 - 65535 seconds; 0: no timeout)
D EFAULT S ETTING
CLI: No timeout
Telnet: 10 minutes
C OMMAND M ODE
Line Configuration
C OMMAND U SAGE
◆ If user input is detected within the timeout interval, the session is kept
open; otherwise the session is terminated.
◆ This command applies to both the local console and Telnet connections.
◆ The timeout for Telnet cannot be disabled.
◆ Using the command without specifying a timeout restores the default
setting.
E XAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#exec-timeout 120
Console(config-line)#
login This command enables password checking at login. Use the no form to
disable password checking and allow connections without a password.
S YNTAX
login [local]
no login
local - Selects local password checking. Authentication is based on
the user name specified with the username command.