Table 33: configuration command modes – Microsens MS453490M Management Guide User Manual
Page 480
C
HAPTER
19
| Using the Command Line Interface
Entering Commands
– 480 –
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
Table 33: Configuration Command Modes
Mode
Command
Prompt
Page
Line
line {console | vty}
Console(config-line)
Access
Control List
access-list ip standard
access-list ip extended
access-list mac
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Class Map
class-map
Console(config-cmap)
Interface
interface {ethernet port |
port-channel id| vlan id}
Console(config-if)
MSTP
spanning-tree mst-configuration
Console(config-mstp)
Policy Map
policy-map
Console(config-pmap)
Time Range
time-range
Console(config-time-range)
VLAN
vlan database
Console(config-vlan)