Microsens MS453490M Management Guide - Manual (Page 525)

C HAPTER 21 | System Management Commands
Line
– 525 –
E XAMPLE
Console(config-line)#password 0 secret
Console(config-line)#
R ELATED C OMMANDS
login (522)
password-thresh (525)
password-thresh This command sets the password intrusion threshold which limits the
number of failed logon attempts. Use the no form to remove the threshold
value.
S YNTAX
password-thresh [threshold]
no password-thresh
threshold - The number of allowed password attempts.
(Range: 1-120; 0: no threshold)
D EFAULT S ETTING
The default value is three attempts.
C OMMAND M ODE
Line Configuration
C OMMAND U SAGE
When the logon attempt threshold is reached, the system interface
becomes silent for a specified amount of time before allowing the next
logon attempt. (Use the silent-time command to set this interval.) When
this threshold is reached for Telnet, the Telnet logon interface shuts down.
E XAMPLE
To set the password threshold to five attempts, enter this command:
Console(config-line)#password-thresh 5
Console(config-line)#
R ELATED C OMMANDS
silent-time (526)