Microsens MS453490M Management Guide - Manual (Page 868)

C HAPTER 37 | Multicast Filtering Commands
IGMP Filtering and Throttling
– 868 –
show ip igmp
snooping mrouter
This command displays information on statically configured and
dynamically learned multicast router ports.
S YNTAX
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4093)
D EFAULT S ETTING
Displays multicast router ports for all configured VLANs.
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
Multicast router port types displayed include Static or Dynamic.
E XAMPLE
The following shows the ports in VLAN 1 which are attached to multicast
routers.
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/10 Static
Console#
IGMP F ILTERING AND T HROTTLING
In certain switch applications, the administrator may want to control the
multicast services that are available to end users. For example, an IP/TV
service based on a specific subscription plan. The IGMP filtering feature
fulfills this requirement by restricting access to specified multicast services
on a switch port, and IGMP throttling limits the number of simultaneous
multicast groups a port can join.
Table 124: IGMP Filtering and Throttling Commands
Command Function Mode
ip igmp filter Enables IGMP filtering and throttling on the switch GC
ip igmp profile Sets a profile number and enters IGMP filter profile
configuration mode
GC
permit, deny Sets a profile access mode to permit or deny IPC
range Specifies one or a range of multicast addresses for a
profile
IPC
ip igmp filter Assigns an IGMP filter profile to an interface IC
ip igmp max-groups Specifies an IGMP throttling number for an interface IC