Microsens MS453490M Management Guide User Manual
Page 712
C
HAPTER
27
| Interface Commands
– 712 –
Egress Rate Limit : Disabled, 1000M bits per second
VLAN Membership Mode : Hybrid
Ingress Rule : Disabled
Acceptable Frame Type : All frames
Native VLAN : 1
Priority for Untagged Traffic : 0
GVRP Status : Disabled
Allowed VLAN : 1(u)
Forbidden VLAN :
802.1Q-tunnel Status : Disable
802.1Q-tunnel Mode : NORMAL
802.1Q-tunnel TPID : 8100(Hex)
Console#
Table 87: show interfaces switchport - display description
Field
Description
Broadcast
Threshold
Shows if broadcast storm suppression is enabled or disabled; if enabled
it also shows the threshold level (
).
Multicast
Threshold
Shows if multicast storm suppression is enabled or disabled; if enabled it
also shows the threshold level (
Unknown-unicast
Threshold
Shows if unknown unicast storm suppression is enabled or disabled; if
enabled it also shows the threshold level (
LACP Status
Shows if Link Aggregation Control Protocol has been enabled or disabled
).
Ingress/Egress
Rate Limit
Shows if rate limiting is enabled, and the current rate limit (
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (
).
Ingress Rule
Shows if ingress filtering is enabled or disabled (
).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
).
Native VLAN
Indicates the default Port VLAN ID (
).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames (
GVRP Status
Shows if GARP VLAN Registration Protocol is enabled or disabled
).
Allowed VLAN
Shows the VLANs this interface has joined, where “(u)” indicates
untagged and “(t)” indicates tagged (
).
Forbidden VLAN
Shows the VLANs this interface can not dynamically join via GVRP
).
802.1Q-tunnel
Status
Shows if 802.1Q tunnel is enabled on this interface (
802.1Q-tunnel
Mode
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel
Uplink (
).
802.1Q-tunnel
TPID
Shows the Tag Protocol Identifier used for learning and switching packets
).