Microsens MS453490M Management Guide - Manual (Page 459)

C HAPTER 18 | Multicast Filtering
Filtering and Throttling IGMP Groups
– 459 –
E NABLING IGMP
F ILTERING AND
T HROTTLING
Use the Multicast > IGMP Snooping > Filter (Configure General) page to
enable IGMP filtering and throttling globally on the switch.
CLI R EFERENCES
◆ "ip igmp filter (Global Configuration)" on page 869
P ARAMETERS
These parameters are displayed:
◆ IGMP Filter Status – Enables IGMP filtering and throttling globally for
the switch. (Default: Disabled)
W EB I NTERFACE
To enables IGMP filtering and throttling on the switch:
1.
Click Multicast, IGMP Snooping, Filtering.
2. Select Configure General from the Action list.
3. Enable IGMP Filter Status.
4. Click Apply.
Figure 279: Enabling IGMP Filtering and Throttling
C ONFIGURING IGMP
F ILTER P ROFILES
Use the Multicast > IGMP Snooping > Filter (Add) page to create an IGMP
profile and set its access mode. Then use the (Add Multicast Group Range)
page to configure the multicast groups to filter.
CLI R EFERENCES
◆ "IGMP Filtering and Throttling" on page 868
C OMMAND U SAGE
Specify a range of multicast groups by entering a start and end IP address;
or specify a single multicast group by entering the same IP address for the
start and end of the range.