Snmp-server 556, Snmp-server – Microsens MS453490M Management Guide User Manual
Page 556
C
HAPTER
22
| SNMP Commands
– 556 –
snmp-server
This command enables the SNMPv3 engine and services for all
management clients (i.e., versions 1, 2c, 3). Use the no form to disable the
server.
S
YNTAX
[no] snmp-server
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
Console(config)#snmp-server
Console(config)#
Notification Log Commands
Enables the specified notification log
GC
Creates a notification log and specifies the target host GC
Shows operation status of configured notification logs PE
Displays the configured notification logs
PE
ATC Trap Commands
Sends a trap when broadcast traffic falls beneath the
lower threshold after a storm control response has
been triggered
IC (Port)
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply
timer expires
IC (Port)
Sends a trap when broadcast traffic falls beneath the
lower threshold after a storm control response has
been triggered and the release timer expires
IC (Port)
Sends a trap when multicast traffic falls beneath the
lower threshold after a storm control response has
been triggered
IC (Port)
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply
timer expires
IC (Port)
Sends a trap when multicast traffic falls beneath the
lower threshold after a storm control response has
been triggered and the release timer expires
IC (Port)
Table 53: SNMP Commands (Continued)
Command
Function
Mode