Microsens MS453490M Management Guide - Manual (Page 764)

C HAPTER 33 | Spanning Tree Commands
– 764 –
revision (767)
max-hops (764)
spanning-tree
transmission-limit
This command configures the minimum interval between the transmission
of consecutive BPDUs. Use the no form to restore the default.
S YNTAX
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)
D EFAULT S ETTING
3
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
This command limits the maximum transmission rate for BPDUs.
E XAMPLE
Console(config)#spanning-tree transmission-limit 4
Console(config)#
max-hops This command configures the maximum number of hops in the region
before a BPDU is discarded. Use the no form to restore the default.
S YNTAX
max-hops hop-number
hop-number - Maximum hop number for multiple spanning tree.
(Range: 1-40)
D EFAULT S ETTING
20
C OMMAND M ODE
MST Configuration
C OMMAND U SAGE
An MSTI region is treated as a single node by the STP and RSTP protocols.
Therefore, the message age for BPDUs inside an MSTI region is never
changed. However, each spanning tree instance within a region, and the
internal spanning tree (IST) that connects these instances use a hop count
to specify the maximum number of bridges that will propagate a BPDU.