Lldp dot3-tlv max-frame, Lldp notification, Lldp dot3-tlv max – Microsens MS453490M Management Guide User Manual
Page 894: Frame, Lldp dot3-tlv max- frame
C
HAPTER
38
| LLDP Commands
– 894 –
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
lldp dot3-tlv max-
frame
This command configures an LLDP-enabled port to advertise its maximum
frame size. Use the no form to disable this feature.
S
YNTAX
[no] lldp dot3-tlv max-frame
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
for information on configuring the
maximum frame size for this switch.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv max-frame
Console(config-if)#
lldp notification
This command enables the transmission of SNMP trap notifications about
LLDP changes. Use the no form to disable LLDP notifications.
S
YNTAX
[no] lldp notification
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
◆
This option sends out SNMP trap notifications to designated target
stations at the interval specified by the
command. Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1
and LLDP-EXT-DOT3 MIBs.