Microsens MS453490M Management Guide - Manual (Page 820)

C HAPTER 35 | Class of Service Commands
Priority Commands (Layer 2)
– 820 –
C OMMAND U SAGE
◆ This command shares bandwidth at the egress port by defining
scheduling weights for SWDRR, or for the queuing mode that uses a
combination of strict and weighted queuing ( page 818 ).
◆ Bandwidth is allocated to each queue by calculating a precise number
of bytes per second that will be serviced on each round.
E XAMPLE
The following example shows how to assign round-robin weights of 1 - 4 to
the CoS priority queues 0 - 3.
Console(config)#queue weight 1 2 3 4
Console(config)#
R ELATED C OMMANDS
queue mode (818)
show queue weight (821)
switchport priority
default
This command sets a priority for incoming untagged frames. Use the no
form to restore the default value.
S YNTAX
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
D EFAULT S ETTING
The priority is not set, and the default value for untagged frames received
on the interface is zero.
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
◆ The precedence for priority mapping is IP DSCP, and then default
switchport priority.
◆ The default priority applies for an untagged frame received on a port
set to accept all frame types (i.e, receives both untagged and tagged
frames). This priority does not apply to IEEE 802.1Q VLAN tagged
frames. If the incoming frame is an IEEE 802.1Q VLAN tagged frame,
the IEEE 802.1p User Priority bits will be used.
◆ The switch provides four priority queues for each port. It can be
configured to use strict priority queuing, SDWRR, or a combination of
strict and weighted queuing using the queue mode command. Inbound