Microsens MS453490M Management Guide - Manual (Page 751)

C HAPTER 31 | Automatic Traffic Control Commands
– 751 –
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-apply
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control alarm-fire-threshold (746)
auto-traffic-control apply-timer (741)
snmp-server enable
port-traps atc
multicast-control-
release
This command sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered and the
release timer expires. Use the no form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc
multicast-control-release
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-
release
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control alarm-clear-threshold (745)
auto-traffic-control action (744)
auto-traffic-control release-timer (742)
show auto-traffic-
control
This command shows global configuration settings for automatic storm
control.
C OMMAND M ODE
Privileged Exec
E XAMPLE
Console#show auto-traffic-control
Storm-control: Broadcast
Apply-timer (sec) : 300
release-timer (sec) : 900