Microsens MS453490M Management Guide - Manual (Page 528)

C HAPTER 21 | System Management Commands
Line
– 528 –
C OMMAND M ODE
Line Configuration
C OMMAND U SAGE
◆ If a login attempt is not detected within the timeout interval, the
connection is terminated for the session.
◆ This command applies to both the local console and Telnet connections.
◆ The timeout for Telnet cannot be disabled.
◆ Using the command without specifying a timeout restores the default
setting.
E XAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
disconnect This command terminates an SSH, Telnet, or console connection.
S YNTAX
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
Specifying session identifier “0” will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.
E XAMPLE
Console#disconnect 1
Console#
R ELATED C OMMANDS
show ssh (618)
show users (507)