Microsens MS453490M Management Guide - Manual (Page 813)

C HAPTER 34 | VLAN Commands
Configuring Voice VLANs
– 813 –
E XAMPLE
The following example sets port 1 to Voice VLAN auto mode.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan auto
Console(config-if)#
switchport voice
vlan priority
This command specifies a CoS priority for VoIP traffic on a port. Use the no
form to restore the default priority on a port.
S YNTAX
switchport voice vlan priority priority-value
no switchport voice vlan priority
priority-value - The CoS priority value. (Range: 0-6)
D EFAULT S ETTING
6
C OMMAND M ODE
Interface Configuration
C OMMAND U SAGE
Specifies a CoS priority to apply to the port VoIP traffic on the Voice VLAN.
The priority of any received VoIP packet is overwritten with the new
priority when the Voice VLAN feature is active for the port.
E XAMPLE
The following example sets the CoS priority to 5 on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan priority 5
Console(config-if)#
switchport voice
vlan rule
This command selects a method for detecting VoIP traffic on a port. Use
the no form to disable the detection method on the port.
S YNTAX
[no] switchport voice vlan rule {oui | lldp}
oui - Traffic from VoIP devices is detected by the Organizationally
Unique Identifier (OUI) of the source MAC address.
lldp - Uses LLDP to discover VoIP devices attached to the port.