Microsens MS453490M Management Guide - Manual (Page 512)

C HAPTER 21 | System Management Commands
File Management
– 512 –
copy This command moves (upload/download) a code image or configuration file
between the switch’s flash memory and an FTP/TFTP server. When you
save the system code or configuration settings to a file on an FTP/TFTP
server, that file can later be downloaded to the switch to restore system
operation. The success of the file transfer depends on the accessibility of
the TFTP server and the quality of the network connection.
S YNTAX
copy file {file | ftp | running-config | startup-config | tftp}
copy running-config {file | ftp | startup-config | tftp}
copy startup-config {file | ftp | running-config | tftp}
copy tftp {file | https-certificate | public-key |
running-config | startup-config}
file - Keyword that allows you to copy to/from a file.
ftp - Keyword that allows you to copy to/from an FTP server.
https-certificate - Keyword that allows you to copy the HTTPS
secure site certificate.
public-key - Keyword that allows you to copy a SSH key from a
TFTP server. ( See "Secure Shell" on page 609. )
running-config - Keyword that allows you to copy to/from the
current running configuration.
startup-config - The configuration used for system initialization.
tftp - Keyword that allows you to copy to/from a TFTP server.
D EFAULT S ETTING
None
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
◆ The system prompts for data required to complete the copy command.
◆ The destination file name should not contain slashes (\ or /), and the
maximum length for file names is 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, “.”, “-”)
◆ The switch supports only two operation code files, but the maximum
number of user-defined configuration files is 16.
◆ You can use “Factory_Default_Config.cfg” as the source to copy from
the factory default configuration file, but you cannot use it as the
destination.
◆ To replace the startup configuration, you must use startup-config as
the destination.