Microsens MS453490M Management Guide - Manual (Page 765)

C HAPTER 33 | Spanning Tree Commands
– 765 –
Each bridge decrements the hop count by one before passing on the BPDU.
When the hop count reaches zero, the message is dropped.
E XAMPLE
Console(config-mstp)#max-hops 30
Console(config-mstp)#
mst priority This command configures the priority of a spanning tree instance. Use the
no form to restore the default.
S YNTAX
mst instance-id priority priority
no mst instance-id priority
instance-id - Instance identifier of the spanning tree.
(Range: 0-4094)
priority - Priority of the a spanning tree instance.
(Range: 0-61440 in steps of 4096; Options: 0, 4096, 8192, 12288,
16384, 20480, 24576, 28672, 32768, 36864, 40960, 45056,
49152, 53248, 57344, 61440)
D EFAULT S ETTING
32768
C OMMAND M ODE
MST Configuration
C OMMAND U SAGE
◆ MST priority is used in selecting the root bridge and alternate bridge of
the specified instance. The device with the highest priority (i.e., lowest
numerical value) becomes the MSTI root device. However, if all devices
have the same priority, the device with the lowest MAC address will
then become the root device.
◆ You can set this switch to act as the MSTI root device by specifying a
priority of 0, or as the MSTI alternate device by specifying a priority of
16384.
E XAMPLE
Console(config-mstp)#mst 1 priority 4096
Console(config-mstp)#