Microsens MS453490M Management Guide - Manual (Page 885)

C HAPTER 38 | LLDP Commands
– 885 –
D EFAULT S ETTING
Holdtime multiplier: 4
TTL: 4*30 = 120 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
The time-to-live tells the receiving LLDP agent how long to retain all
information pertaining to the sending LLDP agent if it does not transmit
updates in a timely manner.
E XAMPLE
Console(config)#lldp holdtime-multiplier 10
Console(config)#
lldp notification-
interval
This command configures the allowed interval for sending SNMP
notifications about LLDP MIB changes. Use the no form to restore the
default setting.
S YNTAX
lldp notification-interval seconds
no lldp notification-interval
seconds - Specifies the periodic interval at which SNMP notifications
are sent. (Range: 5 - 3600 seconds)
D EFAULT S ETTING
5 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ This parameter only applies to SNMP applications which use data stored
in the LLDP MIB for network monitoring or management.
◆ Information about changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the
time of a notification are included in the transmission. An SNMP agent
should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
E XAMPLE
Console(config)#lldp notification-interval 30
Console(config)#