Microsens MS453490M Management Guide - Manual (Page 669)

C HAPTER 25 | General Security Measures
IP Source Guard
– 669 –
IP S OURCE G UARD
IP Source Guard is a security feature that filters IP traffic on network
interfaces based on manually configured entries in the IP Source Guard
table, or dynamic entries in the DHCP Snooping table when enabled (see
"DHCP Snooping" on page 660 ). IP source guard can be used to prevent
traffic attacks caused when a host tries to use the IP address of a neighbor
to access the network. This section describes commands used to configure
IP Source Guard.
ip source-guard
binding
This command adds a static address to the source-guard binding table. Use
the no form to remove a static entry.
S YNTAX
ip source-guard binding mac-address vlan vlan-id ip-address
interface ethernet unit/port
no ip source-guard binding mac-address vlan vlan-id
mac-address - A valid unicast MAC address.
vlan-id - ID of a configured VLAN (Range: 1-4093)
ip-address - A valid unicast IP address, including classful types A, B
or C.
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
D EFAULT S ETTING
No configured entries
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ Table entries include a MAC address, IP address, lease time, entry type
(Static-IP-SG-Binding, Dynamic-DHCP-Binding), VLAN identifier, and
port identifier.
Table 79: IP Source Guard Commands
Command Function Mode
ip source-guard binding Adds a static address to the source-guard binding
table
GC
ip source-guard Configures the switch to filter inbound traffic based
on source IP address, or source IP address and
corresponding MAC address
IC
show ip source-guard Shows whether source guard is enabled or disabled
on each interface
PE
show ip source-guard
binding
Shows the source guard binding table PE