Spanning tree commands, 33 s, Panning – Microsens MS453490M Management Guide User Manual
Page 757: Ommands, Table 99: spanning tree commands
– 757 –
33
S
PANNING
T
REE
C
OMMANDS
This section includes commands that configure the Spanning Tree
Algorithm (STA) globally for the switch, and commands that configure STA
for the selected interface.
Table 99: Spanning Tree Commands
Command
Function
Mode
Enables the spanning tree protocol
GC
Configures the spanning tree bridge forward time
GC
Configures the spanning tree bridge hello time
GC
Configures the spanning tree bridge maximum age
GC
Configures STP, RSTP or MSTP mode
GC
Configures the path cost method for RSTP/MSTP
GC
Configures the spanning tree bridge priority
GC
Changes to MSTP configuration mode
GC
Configures the transmission limit for RSTP/MSTP
GC
Configures the maximum number of hops allowed in
the region before a BPDU is discarded
MST
Configures the priority of a spanning tree instance
MST
Adds VLANs to a spanning tree instance
MST
Configures the name for the multiple spanning tree
MST
Configures the revision number for the multiple
spanning tree
MST
Filters BPDUs for edge ports
IC
Shuts down an edge port if it receives a BPDU
IC
Configures the spanning tree path cost of an interface IC
Enables fast forwarding for edge ports
IC
Configures the link type for RSTP/MSTP
IC
Enables BPDU loopback detection for a port
IC
Configures loopback release mode for a port
IC
Enables BPDU loopback SNMP trap notification for a
port
IC
Configures the path cost of an instance in the MST
IC
Configures the priority of an instance in the MST
IC