Microsens MS453490M Management Guide - Manual (Page 539)

C HAPTER 21 | System Management Commands
SMTP Alerts
– 539 –
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
You can specify up to five recipients for alert messages. However, you must
enter a separate command to specify each recipient.
E XAMPLE
Console(config)#logging sendmail destination-email [email protected]
Console(config)#
logging sendmail
source-email
This command sets the email address used for the “From” field in alert
messages. Use the no form to restore the default value.
S YNTAX
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
E XAMPLE
Console(config)#logging sendmail source-email [email protected]
Console(config)#
show logging
sendmail
This command displays the settings for the SMTP event handler.
C OMMAND M ODE
Normal Exec, Privileged Exec
E XAMPLE
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19