Microsens MS453490M Management Guide - Manual (Page 612)

C HAPTER 24 | Authentication Commands
Secure Shell
– 612 –
c. The client sends a signature generated using the private key
to the switch.
d. When the server receives this message, it checks whether the
supplied key is acceptable for authentication, and if so, it then
checks whether the signature is correct. If both checks
succeed, the client is authenticated.
N OTE :
The SSH server supports up to four client sessions. The maximum
number of client sessions includes both current Telnet sessions and SSH
sessions.
ip ssh
authentication-
retries
This command configures the number of times the SSH server attempts to
reauthenticate a user. Use the no form to restore the default setting.
S YNTAX
ip ssh authentication-retries count
no ip ssh authentication-retries
count – The number of authentication attempts permitted after
which the interface is reset. (Range: 1-5)
D EFAULT S ETTING
3
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#ip ssh authentication-retires 2
Console(config)#
R ELATED C OMMANDS
show ip ssh (617)
ip ssh server This command enables the Secure Shell (SSH) server on this switch. Use
the no form to disable this service.
S YNTAX
[no] ip ssh server
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration