Microsens MS453490M Management Guide - Manual (Page 558)

C HAPTER 22 | SNMP Commands
– 558 –
E XAMPLE
Console(config)#snmp-server contact Paul
Console(config)#
R ELATED C OMMANDS
snmp-server location (558)
snmp-server
location
This command sets the system location string. Use the no form to remove
the location string.
S YNTAX
snmp-server location text
no snmp-server location
text - String that describes the system location.
(Maximum length: 255 characters)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#snmp-server location WC-19
Console(config)#
R ELATED C OMMANDS
snmp-server contact (557)
show snmp This command can be used to check the status of SNMP communications.
D EFAULT S ETTING
None
C OMMAND M ODE
Normal Exec, Privileged Exec
C OMMAND U SAGE
This command provides information on the community access strings,
counter information for SNMP input and output protocol data units, and
whether or not SNMP logging has been enabled with the snmp-server
enable traps command.
E XAMPLE