Microsens MS453490M Management Guide - Manual (Page 460)

C HAPTER 18 | Multicast Filtering
Filtering and Throttling IGMP Groups
– 460 –
P ARAMETERS
These parameters are displayed:
Add
◆ Profile ID – Creates an IGMP profile. (Range: 1-4294967295)
◆ Access Mode – Sets the access mode of the profile; either permit or
deny. (Default: Deny)
When the access mode is set to permit, IGMP join reports are
processed when a multicast group falls within the controlled range.
When the access mode is set to deny, IGMP join reports are only
processed when the multicast group is not in the controlled range.
Add Multicast Group Range
◆ Profile ID – Selects an IGMP profile to configure.
◆ Start Multicast IP Address – Specifies the starting address of a
range of multicast groups.
◆ End Multicast IP Address – Specifies the ending address of a range
of multicast groups.
W EB I NTERFACE
To create an IGMP filter profile and set its access mode:
1. Click Multicast, IGMP Snooping, Filtering.
2. Select Configure Profile from the Step list.
3. Select Add from the Action list.
4. Enter the number for a profile, and set its access mode.
5. Click Apply.
Figure 280: Creating an IGMP Filtering Profile
To show the IGMP filter profiles:
1.
Click Multicast, IGMP Snooping, Filtering.
2. Select Configure Profile from the Step list.