Altera Video and Image Processing Suite User Manual
Page 128
Parameter
Value
Description
Number of color planes in
parallel
1–3, Default = 1
Select the number of color planes in parallel.
Include Avalon-MM interface
On or Off
Turn on if you want to specify clipping offsets
using the Avalon-MM interface.
Clipping method
• Offsets
• Rectangle
Specify the clipping area as offsets from the
edge of the input area or as a fixed rectangle.
Left offset
Positive integer,
Default = 10
Specify the x coordinate for the left edge of
the clipping rectangle. 0 is the left edge of the
input area.
Note: The left and right offset values
must be less than or equal to the
input image width.
Right offset
Positive integer,
Default = 10
Specify the x coordinate for the right edge of
the clipping rectangle. 0 is the right edge of
the input area.
Note: The left and right offset values
must be less than or equal to the
input image width.
Width
Positive integer,
Default = 10
Specify the width of the clipping rectangle.
Top offset
Positive integer,
Default = 10
Specify the y coordinate for the top edge of
the clipping rectangle. 0 is the top edge of the
input area.
Note: The top and bottom offset values
must be less than or equal to the
input image height.
Bottom offset
Positive integer,
Default = 10
Specify the y coordinate for the bottom edge
of the clipping rectangle. 0 is the bottom edge
of the input area.
Note: The top and bottom offset values
must be less than or equal to the
input image height.
Height
Positive integer,
Default = 10
Specify the height of the clipping rectangle.
8-2
Video Clipping Parameter Settings
UG-VIPSUITE
2015.05.04
Altera Corporation
Video Clipping IP Cores