EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 87)

Creating and Starting a Test Case
SONET/SDH Application 73
Typical Test Cases
4. For DS3, select the test
path/mapping.
4a. From the data path
selector, press the
desired mapping
then press the
timeslot from the
Grid tab. Choices
depend on the
selected interface.
See Supported
Paths/Mappings on
page 59 for more
information.
4b. Select the Framing. For more
information, refer to DSn Tabs on
page 269.
4c. For DS1, select the Enable FDL check
box to allow facility data link testing.
FDL is only available for the main DS1 TX/RX port.
4d. For DS1, select the Enable DS0/E0 check box to allow DS0 or E0
testing.
4e. For Pattern, go to step 5.
4f. Press Next or Finish.
4g. Repeat step 4 as required to complete the path/mapping. See
Supported Paths/Mappings on page 59 for more information.
5. Pattern Configuration:
5a. Set the pattern parameters. Refer to Pattern TX
on page 405 and Pattern RX on page 409 for
more information.