EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 474)

Next-Generation Tabs
460 IQS-8100 Series Transport Blazer
VCAT TX - Overview
Group Members
³
Member indicates the timeslot number.
³
SQ (Sequence Indicator): Indicates the member’s selection order from
the test setup. The first member bears the sequence indicator “0” by
default. The SQ number of each member can be changed when
Enable LCAS is disabled. Click on a specific member SQ number and
enter the new number. Possible values are from 0 to 63.
Note: The SQ number(s) changed will only take effect when the Apply SQ button
is pressed.
³
Alarm Generation
³
Type for HOP
LOM (Loss of Multiframe): Generates and maintains a corrupted
OOM1 alignment process.
OOM1 (Out-Of-Multiframe of stage 1): Generates a continuous
error in the MFI1 sequence.
OOM2 (Out-Of-Multiframe of stage 2): Generates a continuous
error in the MFI2 sequence.
³
Type for LOP
LOM (Loss of Multiframe): Generates and maintains a corrupted
OOM1 alignment process.
OOM1 (Out-Of-Multiframe of stage 1): Generates an error in the
Z7/K4 bit (MFAS).
OOM2 (Out-Of-Multiframe of stage 2): Generates an error in Z7/K4
bit 2 Frame Count.
³
On/Off button: Click on the On/Off button to enable/disable the
alarm generation.
³
Arrows: Single arrows move one position up or down in the list.
Double arrows move one page up or down in the list.