EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 308)

DSn Tabs
294 IQS-8100 Series Transport Blazer
DS3/45M TX
Error Injection
Allows manual or automated error injection.
Note: Error injection is not available when the framing is set to Unframed.
³
Type: The following error types are available with both manual and
automated injection modes. Choices are C-bit, F-bit, P-bit, and FEBE.
Choices depend also on the selected framing. The default setting is
C-bit.
³
Amount: Select the amount of error to be generated. Choices are
1 through 50. The default setting is 1.
³
Send button: Press Send to manually generate error(s) according to
the Error Type and the Amount of Errors selected.
³
Rate: Press Rate to select the injection rate for the selected error. The
rate must be within the minimum and maximum values specified. The
default setting is 1.0E-2.
³
Continuous: Generates the selected error to its theoretical maximum
when the Continuous check box is selected. The Continuous check
box is cleared by default.
³
On/Off button: The On/Off button is used to activate/deactivate the
selected automated error at the rate specified or at its theoretical
maximum rate when the Continuous check box is selected. This
setting is disabled (Off) by default.