beautypg.com

Gfp channel tx, Configuration – EXFO IQS-8100 Series Transport Blazer for IQS-600 User Manual

Page 449

background image

Next-Generation Tabs

SONET/SDH Application

435

GFP Channel TX

GFP Channel TX

Press TEST, GFP, and Channel (under GFP TX).

Configuration

³

Client Data Frames FCS enables the presence of the payload FCS for
the client frames. This setting is enabled by default. Not supported with
GFP-F over OPU2 and GFP-T over OPU0.

³

Client Management Frames FCS enables the presence of the payload
FCS for the management frames. This setting is disabled by default.

³

CID (Channel IDentifier) selects the communication channel used for
the signal transmission. Choices are from 00000000 through 11111111
(0 to 255). The default value is 0 when EXI is set to Linear. CID not
available when EXI is set to Null (see GFP Frame TX on page 432).

Note: The CID value is the same for both the Client Management and Data

Frames. CID is not available with GFP over OPU2.