beautypg.com

Ds3 feac tx, Configuration – EXFO IQS-8100 Series Transport Blazer for IQS-600 User Manual

Page 311

background image

DSn Tabs

SONET/SDH Application

297

DS3 FEAC TX

DS3 FEAC TX

The Far-End Alarm and Control signal (FEAC) provides Communication
Channel capability over a DS3 in a network applications using C-bit Parity
configuration.

The DS3 FEAC TX tab is used to configure and send alarms/status
information and control signals (loopback commands) to other network
elements.

Note: The DS3 FEAC tab is available when the DS3 framing is set to C-Bit Parity

(see page 293).

Press TEST, DSn-PDH, and FEAC (under DSn-PDH TX).

Configuration

Enable FEAC: Enables DS3 FEAC codeword configuration and analysis.