EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 104)

Creating and Starting a Test Case
90 IQS-8100 Series Transport Blazer
Typical Test Cases
4c. For STS-48c,
STS-192c,
AU-4-16c, and
AU-4-64c, select
the timeslot from
the Grid tab.
4d. For STS-768c, and
AU-4-256c
mapping, the
timeslot is
automatically
selected in the
Grid tab.
4e. Press Next or Finish.
5. Pattern Configuration:
5a. Set the pattern parameters. Refer to
Pattern TX on page 405 and Pattern
RX on page 409 for more
information.
6. Press Finish to complete the test setup.
The Grid tab closes and automatically
switch to the Alarm summary tab.
7. For additional configuration parameters
and results, refer to Summary Tabs on page 125, Port Tabs on page 137,
SONET Tabs on page 211, SDH Tabs on page 303, BERT Tabs on
page 405, Advanced Tabs on page 411, and Common Tabs on
page 491. For Unframed mode, only Summary, Port, and BERT tabs
are available.
8. Press the Start button to start the test. Refer to Global Test Status and
Controls on page 35 for more information on test management.