EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 270)

SONET Tabs
256 IQS-8100 Series Transport Blazer
Path Signal Label (C2)
Path Signal Label (C2)
The C2 byte is allocated to indicate the content of the STS SPE, including
the status of the mapped payloads.
Note: Selecting the C2 byte from the list will automatically update the C2 byte
from the Path Overhead section and vice versa.
For HOP OH RX tab only:
³
Expected Path Signal Label: Allows selecting the expected Path Signal
Label.
³
Enable PLM-P/UNEQ-P (Payload Label Mismatch - Path / Unequipped -
Path): Enables the Payload Label Mismatch and UNEQ-P monitoring.
C2
(Hex.)
Description
C2
(Hex.)
Description
00* Unequipped 16 Mapping of HDLC over SONET
01 Equipped - Non-Specific 17 SDL with self-synchronization scrambler
02 Floating VT Mode 18 Mapping of HDLC/LAPS
03 Locked VT Mode 19 SDL with use of a set-reset scrambler
04 Asynchronous Mapping for DS3 1A 10 Gbps Ethernet (IEEE 802.3)
05 Mapping under development 1B GFP
12 Asynchronous Mapping for
140M (DS4NA)
CF Reserved (Obsolete HDLC/PPP framed)
13 Mapping for ATM E1
a
to
FC
a
a. These values cannot be selected as Expected Path Signal Label.
STS-1 w/1 VTx Payload Defects, STS-1
w/2 VTx Payload Defects, ... STS-1 w/28
VTx or STS-n/nc with Payload Defects
14 Mapping for DQDB FE Test Signal, ITU-T 0.181 specific mapping
15 Asynchronous Mapping for FDDI FF
a
STS SPE AIS (TCM)