EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 110)

Creating and Starting a Test Case
96 IQS-8100 Series Transport Blazer
Typical Test Cases
6. Pattern Configuration:
6a. Set the pattern parameters. Refer to Pattern TX
on page 405 and Pattern RX on page 409 for
more information.
7. Press Finish to complete the test setup. The Grid tab
closes and automatically switch to the Alarm summary tab.
8. For additional configuration parameters and results, refer to Summary
Tabs on page 125, Port Tabs on page 137, OTN Tabs on page 153,
SONET Tabs on page 211, SDH Tabs on page 303, BERT Tabs on
page 405, Advanced Tabs on page 411, and Common Tabs on
page 491. For Unframed mode, only Summary, Port, and BERT tabs
are available.
9. Press the Start button to start the test. Refer to Global Test Status and
Controls on page 35 for more information on test management.