beautypg.com

Client offset rx, Configuration – EXFO IQS-8100 Series Transport Blazer for IQS-600 User Manual

Page 529

background image

Common Tabs

SONET/SDH Application

515

Client Offset RX

Client Offset RX

Note: Available with ODUflex CBR and Gb Ethernet client.

For ODUflex CBR, press TEST, BERT, and Client Offset.
For Gb Ethernet, press TEST, Gb Ethernet, and Client Offset.

Configuration

Note: The configuration of the expected frequency offset is available with

ODUflex CBR test only.

³

Frequency Offset Analysis

Allows to enable the frequency offset measurements. This setting is
enabled by default for normal mode, and disabled for Through mode.

³

Expected Frequency (bps)

For normal mode, the frequency is set to the configured TX Rate (Refer
to TX Rate on page 407) and the Frequency Offset Analysis check box
is selected.

For Through mode (refer to Creating an OTN (OTU1 and OTU2) Test
Case
on page 92), enter the expected frequency in bps and then select
the Frequency Offset Analysis check box.

BERT

Gb Ethernet