EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 85)

Creating and Starting a Test Case
SONET/SDH Application 71
Typical Test Cases
Creating an Electrical DS1 or DS3 Test Case in Dual
RX Mode (IQS-8105/15/20/30)
The following procedures describe the creation of an electrical DS1 or DS3
test case in Dual RX mode.
To create an Electrical DS1 or DS3 Test in Dual RX mode:
1. Test configuration:
1a. Select the source Clock Mode that will be used
for the test. Refer to Clock Configuration on
page 129 for more information.
1b. Select Dual RX (DS1 or DS3 signals) as the Test
Mode. Refer to Test Configuration on page 126
for more information.
The Coupled check box is automatically
selected for Dual RX mode meaning that the settings for both the
TX and RX signals are the same.
1c. Press Next.
2. Interface connector selection:
2a. From the data path selector, press the desired electrical interface
connector.
BNC for DS3, Bantam or RJ-48c for DS1.
2b. Press Next.