EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 102)

Creating and Starting a Test Case
88 IQS-8100 Series Transport Blazer
Typical Test Cases
2. Interface connector selection:
2a. The Optical port is automatically selected.
Select Framed or Unframed. Framed is
automatically selected in Through or
decoupled mode.
For the IQS-8140-DPSK model, select the
wavelength and invert the polarity if required
(refer to Wavelength (nm) on page 148).
2b. For Decoupled test
mode, both TX and
RX ports have to be
selected and
configured:
First select the
interface type for
TX from the data
path selector then
proceed with the
rest of the test setup steps to set the test parameters for the TX
interface. At the end, do not press Finish yet. Press Back to return
to the RX/TX selection screen and select the interface type for RX
from the data path selector then proceed with the rest of the test
setup steps to set the test parameters for the RX interface.
2c. Press Next.
3. Interface selection.
3a. Press the desired interface: OC-768, or STM-256.
3b. Press Next. When Unframed is selected, press Next and go to
step 5.