EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 410)

Ethernet Tabs
396 IQS-8100 Series Transport Blazer
Error/Alarm TX
Error/Alarm TX
Allows Ethernet alarm/error generation.
Press TEST, Ethernet / Gb Ehternet / 10G Ethernet, and Error/Alarm TX.
PHY Error Injection
Note: PHY error generation is not available with Ethernet in ODUflex, or when
10G Ethernet is mapped in GFP.
³
Type: The following error is available with both manual and automated
injection modes: Symbol for Gb Ethernet and Block for 10G Ethernet.
³
Amount: Allows the selection of the amount of manual error to be
generated. Choices are 1 through 50. The default setting is 1.
³
Send button: Press Send to manually generate error(s) according to
the error type and the amount of error.
³
Rate: Press the Rate field to select the rate for the automated error.
Choices are: 1.0E-02, 1.0E-03, 1.0E-04, 1.0E-05, 1.0E-06, 1.0E-07,
1.0E-08, 1.0E-09 or user definable from 1.0E-09 to 1.0E-02. The default
setting is 1.0E-04.
³
Continuous: Generates the selected error for each generated frame
when the Continuous check box is selected while the On/Off button is
enabled (On). The Continuous check box is cleared by default.
³
On/Off button: The On/Off button is used to activate/deactivate the
selected automated error at the rate specified or continuously. This
setting is disabled (Off) by default.