beautypg.com

Stream, Frame configuration – EXFO IQS-8100 Series Transport Blazer for IQS-600 User Manual

Page 408

background image

Ethernet Tabs

394

IQS-8100 Series Transport Blazer

Configuration

Stream

³

Enable: Allows enabling the stream. The stream will be generated only
when the test is started.

Note: The stream can be enabled/disabled even when the test is started and

running. A stream cannot be enabled if its MAC address is not valid.

Note: The stream is automatically enabled when the test is started and

automatically disabled when the test is stopped.

³

TX Rate: Allows the selection of the stream rate. The default TX rate is
100%. TX Rate is only available when the stream is not enabled.

Unit choices are %, bps, Kbps, Mbps, Gbps, Bps, KBps, MBps, GBps,
fps
, and IFG. The default setting is %.

Frame Configuration

Note: The following frame configuration parameters are only available when the

stream is not enabled.

³

Frame Size (Bytes): Select the frame size for the stream.

Note: Sending traffic with frame size >1518 in switched network may result in

losing all frames.

VLAN

Frame Size

Minimum

Maximum

None

1 Tag

48

52

16000

16000