EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 193)

OTN Tabs
SONET/SDH Application 179
ODU TCM TTI RX
Expected Message
³
SAPI allows editing the expected Source Access point Identifier (TTI
bytes 1 to 15). Available when Enable TIM SAPI is enabled. The default
setting is EXFO TCMi SAPI. The TTI byte 0 is set to NULL (all 0’s).
³
DAPI allows editing the expected Destination Access point Identifier
(TTI bytes 17 to 31). Available when Enable TIM DAPI is enabled. The
default setting is EXFO TCMi DAPI. The TTI byte 16 is set to NULL (all
0’s).
³
Enable TIM
SAPI allows editing the expected Source Access Point Identifier when
the SAPI check box is selected. Enables also the TCMi-TIM alarm
monitoring. The SAPI check box is cleared by default.
DAPI allows editing the expected Destination Access Point Identifier
when the DAPI check box is selected. Enables also the TCMi-TIM alarm
monitoring. The DAPI check box is cleared by default.
Note: “i” is the level (1 to 6) of the selected TCM.