EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 122)

Creating and Starting a Test Case
108 IQS-8100 Series Transport Blazer
Typical Test Cases
Creating an OTN Overclocked
(OTU1e/OTU2e/OTU1f/OTU2f) Test Case (IQS-8130,
IQS-8130NG, and IQS-8130NGE)
To create an OTN overclocked test on an IQS-8130, IQS-8130NG, or
IQS-8130NGE module:
1. Test configuration:
1a. Select the source Clock Mode that will be used
for the test. Refer to Clock Configuration on
page 129 for more information.
1b. Select Normal as the Test Mode. Refer to Test
Configuration on page 126 for more
information.
1c. Make sure the Coupled check box is selected.
1d. Select the Through check box to loop the RX signal to the TX port.
The Clock Mode is automatically set to Recovered when the
Through check box is selected.
1e. Select the OTN Intrusive check box to loop the RX signal to the
TX port with TX overwrite capabilities.
1f. Leave the SONET/SDH Intrusive check box cleared.
1g. Press Next.