EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 107)

Creating and Starting a Test Case
SONET/SDH Application 93
Typical Test Cases
2. Interface connector selection:
2a. From the data path
selector, press the
Optical interface connector. Optical is automatically selected
when OTN Intrusive check box is selected.
2b. For OTU2 select Framed or Unframed. Framed
is automatically selected in Through or
decoupled mode. For OTU1, select Framed.
2c. For Decoupled test
mode, both TX and
RX ports have to be
selected and
configured:
First select the
interface type for
TX from the data
path selector then
proceed with the
rest of the test setup steps to set the test parameters for the TX
interface. At the end, do not press Finish yet. Press Back to return
to the RX/TX selection screen and select the interface type for RX
from the data path selector then proceed with the rest of the test
setup steps to set the test parameters for the RX interface.
2d. Press Next.