EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 569)

SONET/SDH Application 555
22 Power Failure Recovery
The power failure recovery is used to re-create and restart the test that was
running before the power failure. A test that was created and not running
before the power failure will be re-created but not started. The
configuration of the test is saved automatically once the test is created. The
logger, injections, and configuration are periodically saved.
If the power failure occurred while the test case is created, the saved
configuration will be loaded when the IQS-8100 Series is manually started
from IQS Manager. Thus, the test that was running will be re-created,
configured, and restarted.
Note: The power failure recovery is disabled when the GUI terminates normally
or when the test case is cleared.
When Using the Test Timer
Refer to Timer Configuration on page 130 for more information on test
timer.
The test that was running will be re-created and started after a power
failure if all the following conditions are met:
³
The test was running.
³
The start time has not expired during the power failure.
³
The stop time or the duration has not expired during the power failure.
When Using SmartMode
SmartMode is not supported meaning that SmartMode will return to its
default factory settings after a power failure recovery.