Metrohm 797 VA Computrace - Manual (Page 89)

4.3 Exploratory curves
797 VA Computrace – Software
77
Note: The line properties for axis or signal curve lines can be set
with in the
LINE PROPERTIES window (details see Line properties,
section 3.5)
Copy to clipboard
EXPLORATORY CURVES / Plot / Copy to clipboard
Copy the current content of the EXPLORATORY
CURVES window to the clipboard.
Save as enhanced metafile
EXPLORATORY CURVES / Plot / Save as enhanced metafile
Saves the current content of the EXPLORATORY
CURVES window as an enhanced metafile (*.emf).
Change labels
EXPLORATORY CURVES / Plot / Change Y axis text
Modify text label for y axis.
EXPLORATORY CURVES / Plot / Change title
Modify title text, which is displayed above the
curve.
Clear signal curves
A single or all signal curves loaded into the EXPLORATORY CURVES
window can be cleared by selecting the appropriate menu point in
the
EXPLORATORY CURVES window.
EXPLORATORY CURVES / Signal / Clear
Remove the selected signal curve from the EX-
PLORATORY CURVES window.
EXPLORATORY CURVES / Signal / Clear all
Remove all signal curves from the EXPLORATORY
CURVES window.
Signal cursor
EXPLORATORY SPECIFICATION / Signal / Signal cursor
Open the SIGNAL CURSOR window for selection of
measurement points. The X and Y value of the se-
lected point is displayed in the window.