Metrohm 797 VA Computrace - Manual (Page 45)

2.7 Settings menu
797 VA Computrace – Software
33
Note: The working method parameters cannot be changed
during the GLP validation. Optimization of the method should
be done before the GLP validation.
4. Press < continue > one more time; the PLACE SAMPLE window
opens. Fill the measurement vessel as defined and press < Ok >,
the MONITOR window opens and the measurement starts.
5. The Result part of the Validation of Standard Method page of
the GLP WIZARD window opens.
6. Press < continue > one more time; the Summary of GLP valida-
tion page of the GLP WIZARD window opens.
7. Press < Finish >.
Note: Metrohm recommends to check all 4 procedures on the GLP
Wizard page of the GLP WIZARD window . The tests are progressed
in the order as listed.
Database settings
MAIN WINDOW / Settings / General Settings
The Database settings can be defined on the Da-
tabase tab on the GENERAL SETTINGS window.
Note: If you work with the new program version «797 VA
Computrace Software 1.3.x» and try to export to a databa-
se created with an old program version «797 VA Compu-
trace Software 1.X», an error message appears (see Error
message "Please select a new database file"). If you work
with the «797 VA Computrace Software 1.3.x», export only
to databases created with «797 VA Computrace Software
1.3.x».
Manual Transfer Mode
Use default database file when exporting determinations
Determinations are stored directly in the default
database if you export them via
MAIN MENU / File
/ Export To Database .
Ask for database file when exporting determinations
If you export determinations via MAIN MENU / File
/ Export To Database the SELECT DETERMINATION
DATABASE FILE window opens, and you choose
the database file where the current determination
is stored.
Note: The automatic database export directly after deter-
minations is defined on the sheet Export of the working
method.