2 user rights, Define a new user, Change user rights – Metrohm 797 VA Computrace User Manual
Page 218: 3 signals in exploratory mode, Load a signal curve, Define a new user change user rights
8 How to ...?
797 VA Computrace – Software
206
Note: If you switch off the instruments, switch off the 731 Relay
Box first.
8.2 User
rights
Define a new user
1. Open
the
USER RIGHTS
window by clicking on
MAIN WINDOW
/ User / User rights
.
2. Click the
button to open the
ADD NEW USER
window.
3. Enter
the
Name
and
Password
of the new user.
4. Close
the
ADD NEW USER
window by clicking
.
5. Select the new user in the list of all users and set his user rights
(see User rights, section 2.6).
6. Close
the
USER RIGHTS
window by clicking
.
Change user rights
1. Open
the
USER RIGHTS
window by clicking on
MAIN WINDOW
/ User / User rights
.
2. In
the
User rights
tab, select the desired user in the list of all
users and change his user rights (see User rights, section 2.6).
3. In
the
User directories
tab you can define where data and
methods are saved for each specific user.
4. Close
the
USER RIGHTS
window by clicking
.
8.3
Signals in exploratory mode
Load a signal curve
1. Click on
or
MAIN WINDOW
/ Mode / Exploratory
.
2. Click on
or
EXPLORATORY SPECIFICATION
/ File / Load
signal
.
3. Select one or several (Ctrl + Click) signal files
*.sig
in the
OPEN
window and click
.
Note: As soon as a signal curve is measured or loaded, the volt-
ammetric parameter get read only. Should the parameters be
changed before measuring a new signal curve, the button
needs to be clicked.