Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 401)

APS Error Messages
A–7
Display Message Recommended Action Description
ERROR - TOO FEW DATA FILES IN
THIS ARCHIVE FILE
An error occurred while accessing data
files.
Contact your RSI representative.
ERROR - UNABLE TO CALCULATE
PROM SIZE
The processor image is invalid. Resave the file and retry the function.
ERROR - UNABLE TO FIND
PROCESSOR IMAGE
While reading the processor image in
the archive file an error occurred.
Check your disk space by running
CHKDSK" from your DOS prompt. Retry
the function.
ERROR - WRITING DATA RECORD The software is unable to write to the
current hex file.
Check your disk space by running
CHKDSK" from your DOS prompt. On
successful completion retry the function.
ERROR - WRITING END OF FILE
RECORD
The software is unable to write to the
current hex file.
Check your disk space by running
CHKDSK" from your DOS prompt. On
successful completion retry the function.
ERROR - WRITING LRC RECORD The software is unable to write to the
current hex file.
Check your disk space by running
CHKDSK" from your DOS prompt. On
successful completion retry the function.
ERROR CLOSING REPORT LISTING
FILE
During create reports an attempt to close
a report listing failed.
Verify that the path (ipds\lis\slc500)
exists and that the file is not write
protected.
ERROR COPYING FILES The routine called to copy files failed. Check your disk space by running
CHKDSK" from your DOS prompt. On
successful completion retry the function.
ERROR CREATING NEW ARCHIVE
FILE
An error occurred while saving the file
contents to disk.
Check your disk space by running
CHKDSK" from your DOS prompt. On
successful completion retry the function.
ERROR MAPPING LADDER FILE
RUNG
During create reports an error occurred
while attempting to map rung or
address/instruction comments to
corresponding rungs, addresses, or
instructions.
Contact your RSI representative.
ERROR OPENING COMMUNICATION
PROTOCOL FILE
Either a disk read error occurred or the
driver file does not exist in the specified
directory.
Verify that the driver file exists and
execute CHKDSK" from the DOS
prompt. Retry the function.
ERROR OPENING REPORT LISTING
FILE
During create reports an attempt to close
a report listing failed.
Verify that the DOS path contains
(ipds\lis\slc500) and that the file is not
write protected.
ERROR POSITIONING PROCESSOR
FILE POINTER
During create reports an attempt to set a
file pointer to a ladder executable file in
the archive file failed.
Contact your RSI representative.