Offline config, Move the cursor to node 5 and press, The display changes as follows – Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 User Manual
Page 149
Protection
8–7
2.
To claim ownership of nodes 4 and 5, move the cursor to node 4 and press
CONFIG
OFFLINE
CONFIG
SET
OWNER
F3
. Move the cursor to node 5 and press
CONFIG
OFFLINE
CONFIG
SET
OWNER
F3
. The display
changes as follows:
0
TERM
(31)
12
24
1
APS
(31)
13
25
2
500-20
(31)
14
26
3
5/03
(31)
15
27
4
500-40
(31/0)
16
28
5
5/02
(31/0)
17
29
6
18
30
7
19
31
8
20
9
21
10
5/03
(31/10)
22
11
23
F2
STATION
DIAGS
Press a key for desired network function
WHO ACTIVE - Active Station Identification
ESC exits
F1
ONLINE
F3
SET
OWNER
F4
CLEAR
OWNER
F7
MAX
ADDRESS
F8
NODE
ADDRESS
F9
NODE
BAUD
To indicate ownership by a programmer, the node address of the owner is
included in the parentheses with the maximum node address. In this case, to
indicate ownership by terminal 0, “31” changed to “31/0” for nodes 4 and 5.
As long as terminal 0 is running APS, the APS terminal at node 1 cannot
monitor the processor file or access the processor functions at nodes 4 and 5.
The message
PROGRAM OWNER ACTIVE
tells you why you are denied
access.
If terminal 0 exits APS or is disconnected from the network, terminal 1 can use
the Clear Owner function to clear terminal 0’s ownership of a node. Terminal 1
then has access to the node and can claim ownership.
3.
To clear ownership, place the cursor on the desired node and press
CONFIG
OFFLINE
CONFIG
CLEAR
OWNER
F4
.
To succeed you must either be the current owner or the current owner cannot be
active.