Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 398)

Preface
Advanced Programmming Software User Manual
A–4
Display Message Recommended Action Description
CHANNEL CONFIGURATION MAY
CAUSE LOSS OF COMMUNICATIONS
Applies only if you are online. An
incompatibility exists between the 5/03
and the current online configuration
(APS).
Check your online configuration and
retry the function.
CHANNEL CONFIGURATION NOT
AVAILABLE FOR SELECTED
PROCESSOR
A processor other than an SLC 5/03 or
SLC 5/04 is selected.
Verify that an SLC 5/03 or SLC 5/04
processor is selected. Retry the function.
CHANNEL CONFIGURATION
MODIFIED, ACCEPT OR UNDO
CHANGES
The [ESC] or [ALT-U] key was pressed
after a change was selected.
Informational message. No action
necessary.
CHANNEL CONFIGURATION MAY
CAUSE LOSS OF COMMUNICATIONS
Online only - An incompatibility between
the SLC 5/03 or SLC 5/04 and the
current online (APS) configuration exists.
Verify that the selected online
configuration is compatible with an
SLC 5/03. Retry the function.
COMMAND CANNOT BE EXECUTED This message could mean 1) you are
not the program owner; or 2) the file is in
use by another device.
Determine why another node has explicit
access.
COMMENT DATA LOST The text storage capacity of a rung,
address, or instruction comment has
been exceeded.
Install a memory module, change mode,
or install forces.
CONDITION CANNOT BE GENERATED This message indicates either 1) no
memory module exists; 2) the processor
is in fault mode; or 3) no forces are
installed.
Informational message. No action
necessary.
CONFIRMATION TIMEOUT - LOSS OF
COMMUNICATIONS
The communication interface module did
not return the status of the message
sent within 5 seconds.
Check the connection to the DH +
network and retry the function.
CONVERSION SUCCESSFULĆBYTES
CONVERTED
An archive file was successfully
converted into a hex file.
Send the hex file to a prom programmer.
CREATION OF XREF DB ENTRY
FAILED
While attempting to create the cross
reference database during create
reports, a database call generated an
error.
Contact your RSI representative.
CUT/COPY/PASTE FUNCTION NOT
AVAILABLE DURING ONLINE EDITING An attempt to perform a cut/copy/paste
was made during a runtime online edit.
Change to the program online edit mode
and try the cut/copy/paste function
again.
DATA FILES CAN ONLY BE
PROTECTED FOR 5/03 PROCESSOR
TYPES
An attempt to modify program protection
for a non 5/03 processor occurred.
Change the processor to an SLC 5/03
and retry the function.
DATA VALUE CANNOT BE MODIFIED
DUE TO FILE PROTECTION
An attempt to alter an element within a
protected data table was made from the
multiĆpoint list.
Informational message. No action
necessary.