Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 256)

Preface
Advanced Programming Software User Manual
13–6
2. Access the Channel Configuration display by pressing
CONFIG OFFLINE
CONFIG
CHANNEL
CONFIG
F5
. The
following display shows the default parameters for an SLC 5/03 OS301, OS302
processor.
CHANNEL 0 CONFIGURATION
Current Communication Mode: SYSTEM
System Mode Driver: DF1 FULL-DUPLEX
User Mode Driver: GENERIC ASCII
Write Protect: DISABLED
Mode Changes: DISABLED
Mode Attention Character: /1b
System Mode Character: S
User Mode Character: U
Edit Resource/File Owner Timeout: 60 (seconds)
Passthru Link ID: 1 (decimal)
CHANNEL 1 CONFIGURATION
System Mode Driver: DH-485 MASTER
Write Protect: DISABLED
Edit Resource/File Owner Timeout: 60 (seconds)
Passthru Link ID: 2 (decimal)
F2
UNDO
EDITS
Press a key for desired function
REM PROG no forces EDITS: NONE PROC Addr 1
Channel Configuration
F1
ACCEPT
EDITS
F4
CH0 SYS
CONFIG
F7
CH1 SYS
CONFIG
F10
SELECT
OPTION
F5
CH0 USR
CONFIG
Available Function Keys Description
[F1] Accept Edits
Accepts all changes made to the general channel
configuration.
[F2] Undo Edits
Discards any changes made to the general channel
configuration since the last time the Accept Edits key was
pressed.
[F4] Channel 0 System
Configuration
Accesses the channel 0 configuration screen for the selected
system mode communication driver.
[F5] Channel 0 User
Configuration
Accesses the channel 0 configuration screen for the selected
user mode communication driver. This option only applies to
SLC 5/03 OS301, OS302 and SLC 5/04 OS400, OS401
processors.
[F7] Channel 1 System
Configuration
Accesses the channel 1 configuration screen for the selected
system mode communication driver.
[F10] Select Option Changes the value for the currently cursored option.
3. Leave the channel configuration screen by either accepting the edit or undoing
the edit.