Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 305)

Preface
Advanced Programming Software User Manual
16–12
Function Key Description
[F1] Change Radix
Allows you to change the format display of data. Choices are:
Binary, Decimal, HEX/BCD, or ASCII.
[F5] Specify Address
Moves the cursor to any address within the data file or to any
other data file by first pressing [F5], entering the address, and
pressing
[ENTER]
.
[F7] Next File Accesses the next data file.
[F8] Previous File Accesses the previous data file.
2. Change the radix by pressing
CONFIG OFFLINE
CONFIG
CHANGE
RADIX
F1
. The following function keys are
displayed:
Press a key or enter value
(file 2, rung 0)
REM PROG
no forces decimal data decimal addr PROC Addr 1
F3
DECIMAL
DATA
F5
ASCII
DATA
F1
BINARY
F4
HEX/BCD
DATA
3. Press
CONFIG OFFLINE
CONFIG
BINARY
F1
. The display changes to the following:
address 15 data 0 address 15 data 0
N7:0 0000 0000 0000 0000 N7:16 0000 0000 0000 0000
N7:1 0000 0000 0000 0010 N7:17 0000 0000 0000 0000
N7:2 0000 0000 0000 0011 N7:18 0000 0000 0000 0000
N7:3 0000 0000 0000 0000 N7:19 0000 0000 0000 0000
N7:4 0000 0000 0000 0000 N7:20 0000 0000 0000 0000
N7:5 0000 0000 0000 0000 N7:21 0000 0000 0000 0000
N7:6 0000 0000 0000 0000 N7:22 0000 0000 0000 0000
N7:7 0000 0000 0000 0000 N7:23 0000 0100 0100 1010
N7:8 0000 0000 0000 0000 N7:24 0000 0000 0000 0000
N7:9 0000 0000 0000 0000 N7:25 0000 0000 0000 0000
N7:10 0000 0000 0000 0000 N7:26 0000 0000 0000 0000
N7:11 0000 0000 0000 0000 N7:27 0000 0000 0000 0000
N7:12 0000 0000 0000 0000 N7:28 0000 0000 0000 0000
N7:13 0000 0000 0000 0000 N7:29 0000 0000 0000 0000
N7:14 0000 0000 0000 0000 N7:30 0000 0000 0000 0000
N7:15 0000 0000 0000 0000 N7:31 0000 0000 0000 0000
Press a key or enter value
N7:0 =
REM PROG
no forces binary data decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FILE
F1
CHANGE
RADIX