Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 104)

Creating and Editing Ladder Program Files
6–13
1. At the offline Program display press
CONFIG OFFLINE
CONFIG
MONITOR
FILE
F8
, then
CONFIG OFFLINE
CONFIG
SEARCH
F6
or [ALT–S] .
The following function keys are available:
Function Key Description
[F1] Search Type Toggles between Search Instruction/Address, Search &
Replace Instruction/Address, and Edit Zone (SLC 5/03 and
SLC 5/04 only). The replacement of I/O addresses is not
checked against the I/O configuration until you compile and
save the program. This allows you to upgrade a fixed
processor to a chassis program and vice versa.
[F2] Search For Prompts you to enter the search string. If you are using an
SLC 5/03 or SLC 5/04 processor and Edit Zone is the search
type, you have the option of searching for an
inserted/replaced/deleted rung.
[F3] Replace With Appears only when you select the Search & Replace
Instruction/Address mode. This is only valid during offline
programming. Note that the replace pattern must be in the
same format as the search pattern.
[F5] Start Search Starts the search operation. When Search & Replace mode is
in effect, the following additional options are available:
[F1] Replace Ċ Replaces the string with the string specified on
the Replace With Field.
[F2] Skip Ċ Does not change the found string, but finds the
next matching search string.
[F3] Quit Ċ Does not change the found string and
discontinues searching.
[F4] All Ċ Finds all remaining strings and replaces each
occurrence with the specified string on the Replace With Field.
[F7] Toggle Scope Toggles between File and Global. If File is selected, only the
current file is searched. If Global is selected, all of the
program files (2 Ć 255) in the current program are searched.
[F8] Toggle Direct Toggles between Up and Down. Up specifies to search
upward in the file from the current rung. Down specifies to
search downward in the file from the current rung.
[F9] Toggle Wrap Toggles between On and Off for file wrap. On specifies that
when the end of the file is reached, the search continues from
the other end of the file. Off specifies that when the end of the
file is reached, the search stops.
[F10] Save Configuration Saves the search configuration options to disk.